KLVR Co. AR Maglock Kingpin PAL System
Depressing your Kingpin PAL system does two things. In order to be compliant the takedown pin must first open the receiver. That is stage 1 of the PAL System. After the receiver is opened then you can legally release the magazine. That is stage 2 of the PAL System. Provided you installed your AR Maglock system correctly one press of the PAL System will activate Stage 1 first and then Stage 2 to execute a magazine change in your rifle. At no point prior to Stage 2 will you be able to release the magazine.
It's that easy. No more fumbling with reloads. Left-handers are no longer forgotten about. Get your Kingpin PAL system and start speeding up those California Compliant reloads.
***The Kingpin PAL system only comes with the Lever Arm that installs onto your existing AR Maglock and Kingpin equipped rifle.
DISCLAIMER:
KLVR AND ITS PRODUCTS ARE NOT AFFILIATED WITH AR MAGLOCK
PAL SYSTEMS ARE NOT COMPLIANCE DEVICES. THEY ONLY ASSIST IN THE USE OF THE FIXED MAG COMPLIANCE DEVICE ALREADY INSTALLED ON YOUR RIFLE. INSTALLATION OF THE PAL SYSTEM BY ITSELF DOES NOT MAKE A RIFLE FIXED MAG COMPLIANT.
WHEN USING ANY FIXED MAG DEVICE IT IS IMPERATIVE THAT THE USER UNDERSTAND THAT IT IS THEIR RESPONSIBILITY TO INSURE THAT THE RECEIVERS ARE CLOSED PRIOR TO PRESSING THE TRIGGER.
IMPORTANT COMPATABILITY REQUIREMENTS
Make sure you are using the entire AR Maglock Gen 2 or Gen 4 system. This includes their Kingpin rear takedown pin and fixed mag system.
Make sure your system isn't mixed and matched with any Juggernaut Tactical Hellfighter products or ANY other rear takedown pin
Please make sure you don't have any ambidextrous controls such as Ambi Bolt Release. Although some have modified their AR Maglock to work with ambidextrous controls it will not work with the PAL system. In most cases Ambi safeties will work with the PAL
The Kingpin PAL is designed to work with standard MILSPEC lowers and uppers. We cannot guarantee functions with Billet lowers and uppers or mixes of the two.
INSTALLATION
Installing your Kingpin PAL only requires removing your detent and detent spring. This means you will have to remove your castle nut and back plate to do so. Depending on your lower it is possible to install the PAL system without removing the AR Maglock otherwise you will also have to uninstall your AR Maglock and reinstall once the PAL is in place.
Recently Added Products
Phase 5 Social Media
